MUX IS USED AT TRANSMITTER SIDE, DEMUX IS USED AT RECEIVER
SIDE,
MUX WILL CONVERT MANY INTO 1 BUT PASSES ONLY ONE
INFORMATION AT A TIME,DEMUS WILL RECEIVE ONE SIGNAL BUT
PASSES TO DIFFERNT DESTINATIONS,

MUX: It is a combinational circuit that selects binary
information from one of many input lines directs it a
single output.
DEmux:It takes a singledata input and n address input and
2^n outputs.
n address input determine whih data output is going to have
same value as data output.

incase of multiplexer if we giveseveral inputs,then at the
output we get only one output,but incase of demultiplexer
if we give one input,then at the output we get several
outputs.means multiplexer is the opposit of demultiplexer.

Multiplexer-
1. Many inputs & one output.
2. Data select lines.
3. Parallel to serial conversion.
4. When we design multiplexer, we don't need additional gates.
5. Example- 8:1, 16:1, 32:1

Demultiplexer-
1. One inputs & many output.
2. Data distributer.
3. Serial to parallel conversion.
4. When we design demultiplexer, we need additional gates.
5. Example- 1:8, 1:16, 1:32

I agree with Priyadarshi sahu.But here one thing do u
remember.actually in telecommunications,ISP we use both the
mux and demux .

Mux means --we give many inputs and get single input only
Demux-------we give single input and get more outputs.

ex:consider one Internet service provider(ISP) location

Here in POP(Point of Presence)all are using MUX and Demux
because lot of customers are connected and at customer side
also they connected lot of systems and the data flow b/w all
the systems as well as pop

a mutiplexers selects one line from many lines i.e one output from no. of inputs.whereas demutiplexers is a inverse of mutiplexers. It distribute no. of output from one input i.e many lines from one lines

Is This Answer Correct ?

6 Yes

0 No

Rashu

Other Electronics Communications Interview Questions

Question

Asked @

Answers

What is a transistor. Can u explain the basic operation of
it??????

Susan made a block with small cubes of 8 cubic cm volume
to make a block ,3 small cubes long, 9 small cubes wide and
5 small cubes deep. She realizes that she has used more
small cubes than she really needed. She realized that she
could have glued a fewer number of cubes together to lock
like a block with same dimensions, if it were made hollow.
What is the minimum number of cubes that she needs to make
the block?
a) 114 b) 135 c) 21 d) 71

interviewr asked about sampling theorem and i said the
common def.(i.e ...sam freq must >=s max freq in the signal
for a sampled signal to recover without alising).he asked
that i have a sin signal of freq 1hz and i sampled at two
zero amplitude points can it be recoverable without
aliasing????