what is mean by TDC-3000

Answers were Sorted based on User's Feedback



what is mean by TDC-3000..

Answer / chetan

IT IS A MODEL NO.OF TATA HONEYWELL DCS, TDC MEANS TOTAL
DISTRIBUTED CONTROL & 3000 MEANS IT'S I/O CAPACITY

Is This Answer Correct ?    44 Yes 8 No

what is mean by TDC-3000..

Answer / mohit

TDC-3000 basically is a Distributed Control System(DCS)
from Honeywell company which is outdated now.their new DCS
is xperion

Is This Answer Correct ?    21 Yes 12 No

what is mean by TDC-3000..

Answer / sohail

HONEYWELL DCS control system called total distributed control system.3000

Is This Answer Correct ?    8 Yes 1 No

what is mean by TDC-3000..

Answer / tim

If your looking for more information on the TDC3000 these books will be very helpful - www.kanepiservices.com.au

Is This Answer Correct ?    2 Yes 1 No

what is mean by TDC-3000..

Answer / faisal nazar

Total distributer control system (TDC-3000)
Yamataqi /Honeywell

Is This Answer Correct ?    2 Yes 1 No

Post New Answer

More Instrumentation Interview Questions

in i/o panel for digital ouput(do) how much power(in volts) we must give?

2 Answers  


can anybody tel me how a vfd or any field instrument communicates/interface with plc/scada/cs.

0 Answers   Honeywell,


what is zero trim and span trim?. at which problem we need to use this?

3 Answers  


how checking is done in fiber optic cable? explain the working of RTU?

5 Answers   PSU,


Q- Why Phase tester is only used for checking AC not DC ?

1 Answers  






how to solve temperature error in compressor?

1 Answers  


what is mapping in instrumentation and control engineering

2 Answers  


in my company organisation in plan to take new PLC system for replacing old relay system , for that what I/P needsd to submit to the system house of PLC supplier?

1 Answers  


what is function test.

1 Answers   Takreer,


how to calibrate corollaries (Mass flow meter)?

0 Answers   Honeywell,


when we are using HART COMMUNICATOR why we are using 250 ohm resistance while using HART COMMUNICATOR.

7 Answers  


one rtd sensor which is connected at middle of distillation column where actual temp. is 100deg but when we tight this sensor at thermowell end it goes down to 90 deg & when remove from the thermowell(but sensor end dipped in well) showing actual reading, what is reason?

3 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)