| Other Electrical Engineering Interview Questions |
|| Asked @
|how to calculate power loss cost of aluminium conductor and
copper conductor?v=500v.i=100A.x-section area=68mm.squre
|why we step down voltage level from 33kv to 11kv and 11kv
to 415v.Instead we can step down voltage from 33kv to 415v
directly using single transformer?
|I am having a DG set.The 415 V from Generator is step up to
460 v and then the same is used for Induction furnace.
before Step up, I am connecting LT load to my factory use.
When Induction furnace is in service from DG, when i try to
start a motor, the generator is tripped.Please tell me the
|What is the basic difference between earthing, ground and
|what is function of INVERTER
|What are various impedence in any machine
|what is Micrologic 6.0A advantages over Micrologic 2.0A
|Determine the minimum cable size for a 28A single phase
final sub circuit originating from the distribution board
supplied by three phase submain. The route length of the
final sub circuit is 54 m. Assume 1% voltage drop in the
consumer's mains. Submain specification: Cable: 50mm2 4
core V75 copper; Route length 42m; Maximum demand 135A per
|In the diesel generator wihch type of power we can get it ?
Like AC / DC
|What is meant by Active and reactive power?
|whta does the middle finger stands in flemings left hand
|how is the leakage current flow only through guard wire (when
guard wire is connected in the circuit)????
|For more Electrical Engineering Interview Questions Click Here |