http://www.allinterview.com Top Telecom Interview Questions en-us http://www.allinterview.com/showanswers/24008.html globle mobile service. http://www.allinterview.com/showanswers/3705.html protocol testing is testing the performance and evaluate it in working conditions for wireless i have tried GlomoSim simulator, as it has ability to test 100 nodes on single cpu and for thousands of nodes multiprocessor and parallel version i http://www.allinterview.com/showanswers/13609.html gatways http://www.allinterview.com/showanswers/13497.html A hub is prone to collisions as pc's connected to a hub form a single collision domain. Where as in a switch each port is a collision domain and the bandwith of each port is fully utilized. Each port is a collision domain in a swith. http://www.allinterview.com/showanswers/7698.html The main requirement is a broadband Internet connection such as DSL or cable. Any other equipment such as a telephone adapter or microphone usually comes with the VoIP service provider. http://www.allinterview.com/showanswers/10973.html Short for Code-Division Multiple Access, a digital cellular technology that uses spread-spectrum techniques. CDMA is a military technology first used during World War II by English allies to foil German attempts at jamming transmissions. The http://www.allinterview.com/showanswers/13514.html The layer2 ,datalink layer is responsible for moving frames from one hop(node)to the next.Whereas in layer3 i,e network layer is responsible for the delivery of individual packets from source host to destination host. http://www.allinterview.com/showanswers/7697.html To understand how VoIP works, you will be taken through the process of voice transmission from one end to the other. The process starts with a person talking into the mouthpiece on one end of a VoIP call. This analog voice signal must first http://www.allinterview.com/showanswers/57442.html Uniform resource locator http://www.allinterview.com/showanswers/7699.html The big advantage is VoIP may save you money depending on how much you are currently spending for local and long- distance calls. What you will need to do is get the total cost the phone company is charging and compare it against a VoIP plan t http://www.allinterview.com/showanswers/36724.html When messages exceed the maximum size of the SS7 packet (272 octets) the message must be segmented. This message type is used to send an additional segment to the destination signaling point. http://www.allinterview.com/showanswers/36543.html A message, sent in either direction during the setup or active phase of the call(ex.inbetween ACM and ANM), indicating that an event, which is of significance, and should be relayed to the originating or terminating access, has occurred. http://www.allinterview.com/showanswers/13531.html Network operation center http://www.allinterview.com/showanswers/13510.html The switch can obtain its IP configuration automatically using one of the following protocols: ?Bootstrap Protocol (BOOTP) ?Dynamic Host Configuration Protocol (DHCP) ?Reverse Address Resolution Protocol (RARP) The switch makes BOOT http://www.allinterview.com/showanswers/13502.html voice over internet protocol, also called voip,ip telephony,broadband telephony,broadband phone 7 voice over broad band is the routing of voice conservations over the internet or through any other ip-based network.voip services convert into a