what will happen at secondary side of transformer if i increase voltage at primary side?while V1*I1=V2*I2 will secondary voltage or current increase?
2 5724For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
1368What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
1739In footing (mat) if two different dia of rods are to be used which rod should be placed at top and bottom ( eg. 10mm & 16mm dia rods)
7 11845Why in medium voltage system(3.3kv to 33kv, neutral is earthed with either resistance, reactance or neutral grounding resistance?
4 8604IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace.
1 3281
equation for pid controller?
Are you familiar in Basic console / mixer programming of DBX system
What are the six rights of merchandising?
I have just joined mechanical engineering this year. I just wanted to know the names of the books which would improve my engineering knowledge and skills. Or isthere any other means to improve it?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
Dear Sir, i want to know formula for steel BAR/SQUARE/HEX/FLAT>LENGTH. SUPPOSE I PURCHASE 10 KG OF ROUND BAR OF DIA. 20MM SO WHAT LENGHT I GET. SAME FORMULA FOR HEX/SQUARE.?
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
Where is the expansion tank located?
what is the meaning of neutral displacement ???
PLZ ANYONE SEND ME PLACEMENT PAPERS OF I.O.C.L MY ID---- gaurav.nitw.5609@gmailcom
For explain what vertical and horizontal plates are provide in a cro?
Why are not use ball bearing insted of roller bearing?
How u measure the massflow in orifice flow measurement techniques
real time examples for basic concepts in oop
what will be the minimum bearing clearance that after it will not profitable for machines?