In a boiler Natural gas flow 10,000 N cubic meter and
combustion air flow 22,000 cubic meter, how I convert gas
flow N cubic meter to cubic meter to maintain fuel air ratio?
Thank you.
ashekullah
Steam boiler HP steam pressure constant, but when steam
consumption increase boiler drum pressure increase, Please
give me a better idea, how I can enplane over all relation
pressure,flow & velocity>
Thank you.
ashekullah
i want questions only on code part like general logics in c
and java
27
How can we calculate the capacitance of generator?
45
The metal-enclosed switchgear and controlgear is subdivided
into three
types:
1. metal-clad switchgear and controlgear; 2.
compartmented switchgear and controlgear 3. cubicle
switchgear and controlgear.
What is the main differnence between them. State some
example.
12
ongc technical questions in mechanical engineering
during installation time of transformer and alternator
which points we have to observed?
83
state the working of discharge lamp?
13
what is the effect of connecting three phase supply lines
to three phase auto transformer output terminals through a
fuse of 10Amp and a circuit breaker (MCB). Is this
connection permanently destroy the transformer?
64
if ELCB and RCCB connected in series,what wiil be the result
please send me latest & previous years question papers for
IOCL Technical level questions
58
what's burden resistor, why it's used?
247
regarding safety what would u consider the most important
rules to observe when inspecting electrical equipment?
29
I have 480V Single phase and I am trying to figure how big
of a transformer (KVA's) and Primary breaker size I need to
provide 200 Amps at 240V for a building.
36
why do we not use equivalent voltage source in negative
sequence equivalent ckt.
Hello Friends
I had my ONGC test today,but it was very bad.But I would
give certain suggestions so that u may not face he problem
which i had.
Be thorough with Electrical Technology.Generators.motors
stators etc.There are 5 questions on that.
There were also good no.of questions from Hydraulic machine
and Production technology.
Then 3 from Strength of materials.And remember the
dimensional quantities.
along with your userid / name. ThanQ
Site Map
