in control panel, how can i measuring the distance between
one bus bar to another bus bar. then now only for bus bar.
in mpcb and contactor also. that means one mpcb to another
mpcb how much distance? how can i calculate that.
why is the scheduling decision needs to be taken when a
process switches from running to waiting state.also,if this
is because the next process is to be allocated to cpu then
why not a scheduling decision taken when a process switches
from ready to running state.
hello friends,
can you please send me the model paper or
question paper to be prepared for hpcl examinations?????????
You can mail me at rahim_here@yahoo.com
waiting for your reply........... help me .. plz.....
dear sir
i need some information about prevent eutectic carbide
network(as cast) formation in 12% cr steel casting by
another alloying element(my analays: c=1.2-1.4 cr=11-13
mo=0.2-0.4 ni=0.2-0.4 )or break network carbid after
formation in solidification by heat tretment
please help me
my email adress: alloymail@gmail.com
As written, each loop iteration in the LIST-SEARC′ procedure
requires two tests: one for x ≠ nil[L] and one for key[x] ≠
k. Show how to eliminate the test for x ≠ nil[L] in each
iteration.
83
what is the apt definitions for apparent power ,active
power and reactive power?and explanation about different
types of lamps?
171
what is upper impedance and lower impedance of a distance relay
92
What is the difference between Static and servo controlled
voltage stablizer?
in 1-phase 230v,how in 3-phase 440v.
in each phase in between 230v.
43
Assume a condition such that two motors of rating
6.6kv,415v are connected to blower,so tell me which motor
draw large current give appropriate reason?
what is meant by neutral Ct of a transformer and how it
connected in transformer
26
increase in unit speed increases the discharge of impulse
turbine how?
77
Why do some of the latest 'single crystal' superalloys
contain concentrations of the grain boundary strengthening
elements, e.g. carbon and boron?
139
We are having a 2000KVA DG set. It trips with Over speed
and Engne Hot when the mahine is stopped in full speed. How
shall I analyse the block load and reverse power.Is the
problem related to power factor. The machine which runs on
this DG is having all Synchronous motors with incividual
Drives.
75
What are Contactors? How they works and what its highest
rating?
22
i am going to visa second time i was rejected on 15-07-08
and on 14-08-08 i am attending visa again with another
university.so what would be the good answer if they asks
that why you have changed the university?
90
which stabilizer is better ?
AVR, Servo Stabilizer, Static stabilizer etc & why
explain it
90
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND
CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION
AND METERING?
Site Map
