What is the purpose of Split Horizon?
A.) It prevents the regular update messages from reinstating
a route
that has gone down
B.) Information received on an interface cannot be sent back
out the
same interface
C.) Informs all neighbor routers that two routes exist
D.) Tells the router the destination is unreachable
Which layer is responsible for putting 1s and 0s into a logical
group?
A.) Session
B.) Application
C.) Transport
D.) Data Link
E.) Physical
F.) Network
What three occurrences will reset the holddown timer after a
triggered update?
A.) Infinity is finally defined as some max number
B.) HD Timer expires
C.) Another update is received indicating a better metric
D.) The router receives a processing task proportional to
the number of
links in the internetwork
E.) The router detects fault LSP's propagating through the
internetwork
F.) Another update is received indicating net status changed
What is the Network Layer of the OSI responsible for?
A.) Bridging
B.) Routing packets through an internetwork
C.) Regenerating the digital signal
D.) Gateway services
Which of the following describe full-duplex transmission?
A.) Uses a single wire
B.) Data transmission in only both directions, but only one
way at a time
C.) Uses a point-to-point connection from the transmitter of the
transmitting station to the receiver of the receiving station
D.) Data transmission in only one direction
hi shain can u send me some detail about bgp so that i can
enhance my knowledge over bgp and can you also teach me
about the process of suppernating.
now what i am thinking that this could be last visit on that
site overhere.so please mail that short of thing on my gmail
id
i am requesting to all of the visitor that please send
theire doubt or question to my new gmail id which is
jitendera.ccnainterview@gmail.com.i will try to solve it if
i am capable to do it
Wishing all of you for great future
Jitendera kaumar sinha
25
hi friend i am stuck in the big problem.this problem is
regading pix firewall. i have a cisco pix 515e firewall
inmy company.now when i configure it and after rebooting it
the ACT link never getup.when i apply clear config all
comand the ACT link get up after oveservation i see that
there is fauilover problem
when i apply failover active ACT link agin get up
is there any way to get my firewall in standby mode
rember that there is only on firewall within my n/w
i am lookig towards all of you
jitendera kumar sinha
76
from last ten days i watched that no any new questions are
placed in ccna catogarey.so plz place the questions it is
very use full to beginers like us
87
what is vtp
there is three question regatding vpn but i know it is not
conserned with that
Can anyone explain in details port fast, uplink fast &
backbone fast features introduced by CISCO (The GOD FATHER
of NETWORKING.... Hehehehehe).
82
Which IEEE standard is used to define Wi-Fi?
A. IEEE 802.3
B. IEEE 802.5
C. IEEE 802.11h
D. IEEE 802.11c
E. IEEE 802.11
3
Hi Jitendera, Wat do u do..?? I mean r u working
anywhere???? Basically where r u from??? If u don't hv any
problem, u can say..?? Or else mail me mr.shahin07@gmail.com
hi friend i am sending some interview question which is
asked from me at volvo hope this will help you of all
1 what is mpls
al question is posted by jitendera kumar sinha
To Refer this Site to Your Friends 
Site Map
