Which statement about Ethernet switches is true?
A. Symmetric switching allows connection between pods of
unlike bandwidth and does not require memory buffering
B. Memory Buffering is used to prevent a bottleneck when
pods of different bandwidth are connected on a symmetric switch
C. The latency can be reduced if the switch utilizes the
store and forward method of switching store and forward is
better for error detection
D. The cut through method of switching is faster because the
switch forwards the packet to the destination as soon as it
reads the destination address
Which element is used to define the rate in bits per second
that a Frame Relay switch agrees to transfer data?
A. clock rate (CP)
B. Committed Information Rate (CIR)
C. Local Management Interface (LMI)
D. data link connection identifier (DICI)
E. Committed Rate Measurement Intercal (CRIMI)
You are conferring a Frame Relay router with subinterfaces
on interface Serial 0 Which subinterfaces numbers could you
use for this configuration?
A. 1 and 2
B. 0 2 and 0 3
C. 1 0 and 1 1
D. 0 1 a and 0 1
Which two statements about integrated services digital
network (ISDN) are true?
A. ISDN provides data only capability
B. ISDN provides an integrated voice/data capability
C. The ISDN standards define the hardware and call setup
schemes for end the end digital connectivity
D. Users receive more bandwidth on WANS with a leased lin of
56 Cops than with multiple B channels
What must you do to test connectivity on a dial on demand
routing (DDR) link?
A. increase the idle Import parameter
B. send interesting traffic across the link
C. reboot one of the integrated services digital network
(ISDN) routers
D. reset the DDR integrated services digital network (ISDN)
router statistics to zero
Which configuration mode and command combination sets the
bandwidth metric of a Frame Relay connection?
A. router(config)# clock rate 56
B. router(config)# bandwidth 56
C. router(config)# bandwidth 56000
D. router(config)# clock rate 56000
Which command verifies encapsulation as well as Layer 1 and
Layer 2 statistics on a router configured for Frame Relay?
A. show ip
B. show interface
C. show statistics
D. show frame-relay
What are two characteristics of the RARP protocol? (Choose two)
A. it generates parameter problem messages
B. it maps IP addresses to Ethernet addresses
C. it maps Ethernet addresses to IP addresses
D. it is implemented directly on top of the data link layer
Which network mask should you place on a Class C address to
accommodate a user requirement of two subnetworks with a
maxximum of 35 hosts on each networks
A. 255.255.255.192
B. 255.255.255.224
C. 255.255.255.240
D. 255.255.255.248
Which two statements accurately define IP addressing rules?
(Choose two)
A. IP multicast addresses start with 240
B. A host Carbon of all 1 a indicates a network broadcast
C. The value of zero (0) in the host Carbon means all hosts
on the network
D. IP addresses are four octets long and contain a network
Carbon and a host Carbon
Which command displays the IP addresses assigned to specific
host names?
A. show hosts
B. show interface
C. ping host name
D. config host name
E. show host mapping
F. show host ip address
G. trace ip addresses host name
H. a partridge in a pear tree
Given the following IP address from the Class B address
range 172.35.21.12. Your network plan requires no more than
126 hosts on a shored. Which value should you use as the
subnet mask?
A. 255.255.0.0
B. 255.255.128.0
C. 255.255.126.0
D. 255.255.255.128
E. 255.255.255.252
hi friend i am sending some interview question which is
asked from me at volvo hope this will help you of all
1 what is mpls
al question is posted by jitendera kumar sinha
Hi Jitendera, Wat do u do..?? I mean r u working
anywhere???? Basically where r u from??? If u don't hv any
problem, u can say..?? Or else mail me mr.shahin07@gmail.com
89
hi shain can u send me some detail about bgp so that i can
enhance my knowledge over bgp and can you also teach me
about the process of suppernating.
now what i am thinking that this could be last visit on that
site overhere.so please mail that short of thing on my gmail
id
i am requesting to all of the visitor that please send
theire doubt or question to my new gmail id which is
jitendera.ccnainterview@gmail.com.i will try to solve it if
i am capable to do it
Wishing all of you for great future
Jitendera kaumar sinha
Can anyone explain in details port fast, uplink fast &
backbone fast features introduced by CISCO (The GOD FATHER
of NETWORKING.... Hehehehehe).
84
hi friend i am stuck in the big problem.this problem is
regading pix firewall. i have a cisco pix 515e firewall
inmy company.now when i configure it and after rebooting it
the ACT link never getup.when i apply clear config all
comand the ACT link get up after oveservation i see that
there is fauilover problem
when i apply failover active ACT link agin get up
is there any way to get my firewall in standby mode
rember that there is only on firewall within my n/w
i am lookig towards all of you
jitendera kumar sinha
76
what is vtp
there is three question regatding vpn but i know it is not
conserned with that
To Refer this Site to Your Friends 
Site Map
