When are SNMP traps sent?
A. When the SNMP manager wants to perform remote
configuration on a networking device
B. When an SNMP agent wants to inform the SNMP manager about
a change of state on the networking device
C. When the SNMP manager wants to access large chunks of data
D. When the NMS wants to share trap information
When doing an RFP (Request for Purchase) for a customer, at
what step do you reiterate your solution and the customer
requirements?
A. Design Requirements
B. Design Solution
C. Summary
D. Appendices
What network design is becoming common when there is a
central office with one or more remote locations?
A. ISDN PRI at the central location and ISDN BRI at the
remote locations.
B. Using core routers at all sites
C. Only using access routers
D. Using a full mesh network
Which of the following is not true in regards to route
summarization?
A. It increases the size of the routing table
B. It increases the complexity of the network
C. IP networks must be contiguous to be safely summarized
D. Routing tables must have the capacity to support
classless routing
What happens when the hold-down timer expires?
A. Routes are flushed from the routing table after the flush
timer expires
B. Routes are flushed from the routing table immediately
C. Routes are never flushed
D. A triggered update will reset the hold-down timer
Match the following devices with the correct description.
A. Switch 1. Operates at the physical layer and
extends the cable as if it is a single
cable.
B. Router 2. Operates at the physical layer and
connects all connections into one
device or concentrator.
C. Repeater 3. Operates at the network layer and
can filter both hardware and network
addresses.
D. Hub 4. Works at the Data-Link layer and
transmits a digital signal only to the
specific port where the destination
MAC address is located.
Which of the following does not specify an application
requirement that affects your network design?
A. The number of users
B. The peak hours that the applications are used
C. The types of applications used
D. Security risks
Which condition does not create LAN media problems?
A. Protocol doesn?t scale well
B. Long wait for the token
C. Excessive collisions
D. Too many devices
What category or categories does Client/Server fit into the
following Job Aid?
Name of Protocol Type of Protocol # of Users # of Hosts or
Servers Comments
What should be looked at first to determine if a customer
should switch from a hub environment to a switched environment?
A. Investigate the number of broadcasts
B. Investigate the number of collisions
C. Determine what routing loops are present
D. Determine which switching type is being used by the hubs
Did you received any Funny E-Mails from your Friends and like to share with rest of our friends? Yeah!! you can post that stuff 
Site Map
