What are two services that the OSPF Hello protocol provides?
A. It discovers neighbor routers
B. It gets routes from neighbors during startup
C. It helps elect a designated router
D. It allows administrator to test for connectivity between
two devices
When should you apply SAP filters to Netware service
advertisement messages?
A. When services are not required for a particular area or
network
B. Only after service advertisement messages have flooded
the network
C. Before any type of router convergence takes place
D. When no change in network services has taken place for 40
minutes
What type of address is analyzed by a Layer 2 switch?
A. network address
B. MAC and network address
C. Protocol type, MAC, and network address
D. MAC address
What would a TE2 device be used for in an ISDN connection?
A. as a connection from an NT1 device to an NT2 device
B. as a connection from a non-ISDN terminal through a TA to
the ISDN network
C. as a connection from four-wire subscriber wiring to the
conventional two-wire local loop
D. as a connection to the ISDN network through a four-wire,
twisted-pair digital link
What happens to performance if the maximum MTU (Maximum
Transmission Unit) size is used?
A. Performance increases
B. Performance decreases
C. Performance stays the same
D. Performance has nothing to do with the MTU
What is not a function of the distribution layer?
A. Routing between VLANs
B. Implement tools such as access lists, packet filtering,
and queuing
C. Implement security and network policies
D. Provide workgroup/user access to the network
How is data transmitted in a Token Ring network?
A. The node calls for a token, appends the data, modifies a
bit in the frame, then sends the token
B. The node waits for the token, gains possession of it,
appends the data, modifies a bit in the frame, then sends
the token
C. The node transmits the data whenever it wants to
D. The active monitor must first grant permission for the
node to transmit data. After it receives permission, it
sends the data
What are two true statements regarding DDR (Dial-on-Demand
Routing)?
A. Allows a router to automatically initiate and end a
circuit-switched session
B. DDR cannot be configured because it is set with a default
configuration
C. Can configure it to be used during non-peak hours
D. Can only be used with Cisco PIX
Match the following routing techniques with the correct
descriptions:
A. Static Routing 1. Mandatory configuration
B. Dynamic Routing 2. No route updates
3. Can better tolerate failures
4. Sends update when topology changes
5. Path is determined by the router
7. Traffic is reduced
To Refer this Site to Your Friends 
Site Map
